If you have hard water in your home, then it is wise for you to consider removing the minerals in the fluid with the assistance of a water softener. Most people understand that this device will help to reduce the mineral deposits that build up on your sinks, bathtubs, and cooking pots. The softener with actually do more than that and help to do a variety of other things as well. To learn about a few of these things that you probably do not know, keep reading.
Reduce Skin Infection Risks
When you take a shower, you probably can tell that there is a film leftover across your skin that cannot be released by the water in your home. This is likely to leave you feeling unclean after a shower. This problem stems from the fact that you will need to use more soap when you have hard water. The calcium and magnesium ions within the water force the soap to build a scum, but not a lather. This occurs as the positively charged ions in the hard water bond to the negatively charged soap ions. You will then need to use more and more soap until it lathers. The soap scum that is created during the bonding process does not dissolve in water. This causes the scum to attach itself to the skin and remain after you dry off.
While soap scum stuck to the skin may simply seem like a nuisance, the film actually creates a sticky surface that allows bacteria to cling to your body. This bacteria can then find its way into small cracks and openings in the skin and cause an infection to form. Not only can bacteria stick to the soap scum, but so can fecal matter. This can often be seen in babies who form diaper rashes.
A water softener can reduce skin infection risks substantially. While you wait to have the device installed, make sure to use a detergent when you and other family members bathe instead of a soap. Detergents are not negatively charged in the same way that soaps are, and they work to force dirt and oil off the skin to leave it clean. Detergents are typically not produced for showering purposes; most products are made for household cleaning. However, you can use dish detergent to clean yourself when taking a bath or shower since it it so gentle.
Keep Water Heaters Efficient
Your entire plumbing system is affected negatively by the hard water in your home. The plumbing pipes, especially the hot water ones, will fill with the magnesium, calcium, and other minerals in your water. These minerals are attracted to the metal pipes and they build a crust on them. This same sort of thing happens inside your water heater. Specifically, the heavy minerals sink to the bottom of the heater and attach to the bottom of the tank and to the heating elements. If your heater is a gas powered variety, then heat will need to move through the scale across the bottom of the tank. If you have an electric one, then it will have to force through the residue on the heating elements. This makes the heater work harder and use more energy, and the result is increased costs for you.
A water softener will ensure the efficiency of your water heater. However, you will need to flush out the mineral build up after you install the softener to experience the efficiency. The best way to do this is to use vinegar to dissolve the minerals, and water to force the vinegar and debris out of the tank. You should first use the bottom drain on the heater and an attached hose to drain the water completely. This will release all the hard water from the tank. Remove the vent cap or the threaded sacrificial anode from the top of the water heater so you can access the interior.
Use a flashlight to peer into the tank through the opening and turn the handle on the water inlet pipe so that water starts to fill the tank. When about one-quarter of the tank is full, add two to three gallons of white vinegar to the opening in the top of the tank. Allow the vinegar to sit overnight. Empty the tank afterwards and fill it with fresh water when you are done. For more information, contact a company like Johnson Water Conditioning.